中国激光, 2008, 35 (8): 1177, 网络出版: 2008-08-16   

基于PLZT开关的全光纤单模调Q掺Yb3+光纤激光器

All Fiber Single-Mode Q-Switched Ytterbium-Doped Fiber Laser Based on PLZT Switch
作者单位
1 中国工程物理研究院激光聚变研究中心, 四川 绵阳 621900
2 中国工程物理研究院研究生部, 四川 绵阳 621900
3 西安通信学院军用光纤通信教研室, 陕西 西安 710106
摘要
PLZT电光陶瓷具有良好的透明性、高电光系数等特性,用来实现全光纤调Q开关具有很大的优势。分析了PLZT全光纤调Q开关的原理,测量了调Q开关的时间波形,研究了基于PLZT开关的全光纤单模环形调Q掺Yb3+光纤激光器。抽运光功率为180 mW,重复频率为1 kHz时,得到峰值功率25.6 W,脉冲宽度80 ns,光谱宽度1 nm,脉冲能量2.0 μJ的调Q脉冲。此外,分别研究了抽运功率和重复频率对脉冲峰值功率和脉冲宽度的影响,结果表明,同一重复频率情形下,随着抽运功率的升高,峰值功率增大,脉冲宽度降低; 同一抽运功率水平下,随着重复频率的增大,脉冲的峰值功率减小,脉冲宽度增大。
Abstract
PLZT electro-optic (EO) ceramic has good transparency and high EO effect. It has many advantages for realizing the all-fiber Q-switch. The principle of Q-switch based on PLZT was analyzed. And the time distribution of the Q-switch was measured. An all fiber single-mode actively Q-switched ytterbium-doped ring fiber laser based on PLZT switch was studied in experiment. The peak power, pulse width, spectral width and pulse energy of the Q-switched pulse are 25.6 W, 80 ns, 1 nm and 2.0 μJ respectively. At the same time, the effect of the pump power and repetition rate on pulse width and peak power was presented. The results show that the peak power of the pulse increases with the pump power and the pulse width decreases at the same repetition rate, and the pulse width increases with the repetition rate and the peak power decreases at the same pump power.

许党朋, 李明中, 王建军, 张锐, 林宏奂, 车雅良, 卢振华. 基于PLZT开关的全光纤单模调Q掺Yb3+光纤激光器[J]. 中国激光, 2008, 35(8): 1177. Xu Dangpeng, Li Mingzhong, Wang Jianjun, Zhang Rui, Lin Honghuan, Che Yaliang, Lu Zhenhua. All Fiber Single-Mode Q-Switched Ytterbium-Doped Fiber Laser Based on PLZT Switch[J]. Chinese Journal of Lasers, 2008, 35(8): 1177.

本文已被 1 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!