强激光与粒子束, 2010, 22 (2): 311, 网络出版: 2010-05-28  

电解抛光法制备金属钨箔膜

Preparation of tungsten foil by electropolishing
作者单位
1 中国工程物理研究院 激光聚变研究中心,四川 绵阳 621900
2 西华师范大学 物理与电子信息学院,四川 南充 637900
摘要
研究了在硫酸甲醇体系中进行电解抛光制备状态方程(EOS)靶用钨薄膜。分析了钨的阳极极化曲线,对薄膜的表面形貌、晶粒取向、密度和厚度一致性进行了测试和分析,并制备出均方根粗糙度小于50 nm、厚度一致性好于99%、能够保持原材料密度的钨箔膜,满足激光驱动材料高温高压状态方程研究的标准靶材料的需求,证明电解抛光是制备低表面粗糙度、块材密度的EOS所用金属箔材的有效手段。
Abstract
The preparation of the tungsten foil for equation of state(EOS) target was studied by electropolishing in sulfuric acid-methanol. The anodic polarization curve of the tungsten foil was analyzed,and the surface topography,grain orientation,density and thickness uniformity were tested. The tungsten foil was prepared with high surface quality (RMS roughness less than 50 nm) and thickness uniformity beyond 99%,and could keep the density of raw materials. This foil could satisfy the requirement of laser driven materials for the research of high temperature and pressure EOS. Thus electropolishing is a significant method for preparating the foil which can fulfill the requirement of EOS target.

宋萍, 邢丕峰, 谌家军, 李朝阳, 谢军, 郑凤成. 电解抛光法制备金属钨箔膜[J]. 强激光与粒子束, 2010, 22(2): 311. Song Ping, Xing Pifeng, Chen Jiajun, Li Chaoyang, Xie Jun, Zheng Fengcheng. Preparation of tungsten foil by electropolishing[J]. High Power Laser and Particle Beams, 2010, 22(2): 311.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!