光学技术, 2011, 37 (4): 429, 网络出版: 2011-09-20  

1.5m级大口径标准镜面支撑系统的研究

Research on support system for 1.5m aperture mirror
作者单位
1 中国科学院研究生院, 北京 100049
2 中国科学院南京天文仪器研制中心, 江苏 南京 210042
3 南京中科天文仪器有限公司, 江苏 南京 210042
摘要
现阶段科研检测仪器对光学镜面的面形精度要求越来越高。光学镜面的口径越大, 自重导致的变形问题越严重。为了保证大口径标准镜在法线水平状态下的面形精度, 提出了侧面钢带支撑和杠杆平衡重锤卸荷的组合支撑结构, 与传统使用的钢带支撑、水银带支撑方式作了比较, 并通过ansys有限元分析软件建立的模型对几种不同侧支撑方法进行了分析比较, 采用拟合方法计算了镜面在受力变形条件下的PV值和RMS值。结果表明, PV≤λ/38, RMS≤λ/164,比其他两种侧支撑更能保证镜面的面形精度, 解决了在法线水平放置情况下大口径标准镜面支撑中面形变化较大的问题。
Abstract
With the developing of mirror’s aperture, the weight of mirror which leads to a variety of mirror deformation is becoming larger. A reasonable support system must be determined to reduce the distortion as much as possible. The scheme gives a support system which consists of the steel strip side support and the back of balance weight support, and compared with other support structures. The PV value and the RMS value of the deformation are calculated to explain the advantage of this system, the problem of large-aperture mirror support is solved.

刘永奇, 吴金虎, 胡明勇, 马骥. 1.5m级大口径标准镜面支撑系统的研究[J]. 光学技术, 2011, 37(4): 429. LIU Yongqi, WU Jinhu, HU Mingyong, MA Ji. Research on support system for 1.5m aperture mirror[J]. Optical Technique, 2011, 37(4): 429.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!