光子学报, 2013, 42 (11): 1360, 网络出版: 2013-12-16  

信号波形调制多阶光盘信道部分响应多项式与均衡器的设计

Partial Response Polynomial and Equalizer Design for Signal Waveform Modulation Multilevel Disc
作者单位
1 北京理工大学 光电学院,北京 100081
2 光电成像技术与系统教育部重点实验室,北京 100081
3 清华大学 光盘国家工程研究中心,北京 100084
摘要
采用信号波形调制多阶记录技术的多阶光盘,其读出信道识别采用了部分响应最大似然检测技术.这种多阶记录方式在提高记录密度的同时,也增加了光盘信道建模的复杂性和非线性.对此,本文提出了一种适用于这种高密度光盘的部分响应多项式及相应均衡器的优化参量设计的新方法.通过寻找光盘读出的高频信号功率谱密度曲线中有用信息频段与噪音频段的频率临界点,设计并实现了优化的部分响应多项式参量及与之匹配的部分响应均衡器,从而有效地提高了光盘读出信号的信噪比,降低了信号识别的误码率.这种方法也适用于蓝光光盘等其他高密度基带传输信道的部分响应最大似然检测系统的设计.
Abstract
The multilevel disc, which uses the signal waveform modulation method for modulation and recording, employs the partial response maximum likelihood detection techniques for the readout channel recovery. With improving the recording density, the complexity and nonlinearity of the optical disc channel modeling will also increase. Therefore, a optimized design method of the partial response polynomial and the corresponding equalizer design were introduced to solve it. By finding the critical frequency point between signal frequency band and noisy frequency band in the power spectral density curve of the disc readout signal, the optimized parameters of the partial response polynomial and the partial response equalizer were designed, thus effectively improving the optical readout signal to noise ratio, reducing the error rate of the signal recognition. And this method can also be applied to the partial response maximum likelihood detection system of bluray and other highdensity baseband transmission channel.

张龙, 倪国强, 裴京, 杨波. 信号波形调制多阶光盘信道部分响应多项式与均衡器的设计[J]. 光子学报, 2013, 42(11): 1360. ZHANG Long, NI Guoqiang, PEI Jing, YANG Bo. Partial Response Polynomial and Equalizer Design for Signal Waveform Modulation Multilevel Disc[J]. ACTA PHOTONICA SINICA, 2013, 42(11): 1360.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!