强激光与粒子束, 2013, 25 (12): 3307, 网络出版: 2013-12-16  

环形抛光中频误差的计算模拟

Calculation and simulation on mid-spatial frequency error in continuous polishing
作者单位
成都精密光学工程研究中心, 成都 610041
摘要
通过建立环形抛光的去除模型,从理论上分析了转速比、槽形、元件摆动对于抛光结果的影响,并分析了中频误差产生的原因。模拟结果表明: 转速比的差异会产生较大的低频误差,而中频误差会随着低频误差的降低而降低; 槽形是中频误差的主要来源,复杂的非对称不规律槽形使抛光路径复杂化,降低中频误差; 同时元件的小幅度摆动能够使抛光更加均匀,减小定心式抛光造成的元件表面规则状纹路结构,从而有效减小元件的中频误差。
Abstract
Based on theoretical model of continuous polishing, the influence of processing parameters on the polishing result was discussed. Possible causes of mid-spatial frequency error in the process were analyzed. The simulation results demonstrated that the low spatial frequency error was mainly caused by large rotating ratio. The mid-spatial frequency error would decrease as the low spatial frequency error became lower. The regular groove shape was the primary reason of the mid-spatial frequency error. When irregular and fitful grooves were adopted, the mid-spatial frequency error could be lessened. Moreover, the workpiece swing could make the polishing process more uniform and reduce the mid-spatial frequency error caused by the fix-eccentric plane polishing.

谢磊, 张云帆, 游云峰, 马平, 刘义彬, 鄢定尧. 环形抛光中频误差的计算模拟[J]. 强激光与粒子束, 2013, 25(12): 3307. Xie Lei, Zhang Yunfan, You Yunfeng, Ma Ping, Liu Yibin, Yan Dingyao. Calculation and simulation on mid-spatial frequency error in continuous polishing[J]. High Power Laser and Particle Beams, 2013, 25(12): 3307.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!