激光技术, 2017, 41 (2): 247, 网络出版: 2017-03-29   

微水导激光切割玻璃的耦合装置设计

Design of coupling device for laser cutting guided by water beam
作者单位
1 五邑大学 机电工程学院, 江门 529020
2 五邑大学 应用物理与材料学院, 江门 529020
摘要
为了解决激光切割钢化玻璃过程中由于热应力导致产生裂纹并发生破裂的技术难题, 建立了光液耦合模型, 采用FLUENT软件进行了耦合腔内多场分析, 获得了微水导激光切割钢化玻璃的工艺参量。结果表明, 在喷口口径为0.4mm、水束压力为20MPa、激光功率为48W、切割速率为20mm/s的工艺条件下, 厚度为0.5mm及1.0mm的玻璃试样的切割表面均比较光滑、基体内无微裂纹存在, 切缝宽度约为100μm。该双注水口耦合装置的设计是合理的, 能够满足钢化玻璃切割工艺的要求。
Abstract
In order to solve the crack caused by thermal stress during the process of laser cutting for the toughened glass, the FLUENT software was adopted to analysis the water presure and the stability of water beam based on water & laser coupling model, and the optimised parameters were obtained. Then experiment based on the optimised parameters was conducted to verify the anslysis results. The results show that, incision surfaces of both No.1 and No.2 samples are smooth and slot with the width of 100μm under the condition of nozzle diameter 0.4mm, water pressure 20MPa, laser power 48W and cutting speed 20mm/s. Thedesign of coupling device with two water filling nozzles is applicable in the whole process of laser cutting for the toughened glass.

杨保健, 谢顺德, 代福. 微水导激光切割玻璃的耦合装置设计[J]. 激光技术, 2017, 41(2): 247. YANG Baojian, XIE Shunde, DAI Fu. Design of coupling device for laser cutting guided by water beam[J]. Laser Technology, 2017, 41(2): 247.

本文已被 3 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!