强激光与粒子束, 2017, 29 (3): 036017, 网络出版: 2017-03-29  

基于JLAMT可视化建模的JMCT模拟计算

Simulation of JMCT based on JLAMT visualized modeling tool
作者单位
1 华北电力大学 核科学与工程学院, 北京 102206
2 国家核电技术有限公司 北京软件技术中心, 北京 100029
3 北京应用物理与计算数学研究所, 北京 100094
摘要
JMCT是中国工程物理研究院高性能数值模拟软件中心粒子输运团队自主研发的三维蒙特卡罗模拟软件,JLAMT为其前处理可视化建模工具。使用JLAMT和JMCT程序对B&W,KRITZ,BEAVRS等系列基准题进行了模拟,并对有效增殖系数及计数功能进行了对比分析。其中有效增殖系数计算结果与MCNP5的最大偏差为KRITZ2装载方案19基准题的89.1 pcm,除BEAVRS基准题外的计数结果与MCNP5的偏差基本小于2%,平均偏差在1%左右; BEAVRS基准题功率分布模拟结果与MCNP5及实测值最大偏差分别为7.06%,16.6%,控制棒价值计算与MCNP5及实测值均吻合较好。
Abstract
The 3-D Monte Carlo transport code JMCT is developed by Software Center for High Performance Numerical Simulation independently and JLAMT is its pre-processing visualized modeling tool. Benchmarks including B&W, KRITZ, BEAVRS et al were simulated by JMCT and MCNP5 codes, in addition, the effective multiplication factors and tally results were compared with the MCNP5 code and measured data separately. Effective multiplication factor calculations between two codes agree well with each other within 89.1 pcm for the KRITZ2 benchmark, the relative difference in power distribution between JMCT and MCNP5 is below 2% mostly, average difference is about 1%; as for BEAVRS benchmark, the maximum differences of the core radial power distribution of JMCT compared to MCNP5 and measurements are 7.06% and 16.6% respectively, JMCT control rod bank worth calculation results show good agreement of JMCT with MCNP5 and measurement.

郑俞, 全国萍, 李刚. 基于JLAMT可视化建模的JMCT模拟计算[J]. 强激光与粒子束, 2017, 29(3): 036017. Zheng Yu, Quan Guoping, Li Gang. Simulation of JMCT based on JLAMT visualized modeling tool[J]. High Power Laser and Particle Beams, 2017, 29(3): 036017.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!