为了研究以单管半导体激光器为基本单元的高功率、高亮度波长合束光纤耦合模块，设计出新型光纤激光器泵浦模块，基于ZEMAX光学设计软件等设计了一种由30支单管半导体激光器组成、可输出3种波长光束的光纤耦合模块。将经快慢轴整形、空间合束、波长合束、光路转向及聚焦的光束耦合进入芯径105 μm、数值孔径0.22的普通光纤，最终得到尾纤输出端高于357.91 W的输出功率，光纤耦合效率为99.42%，光功率密度为27.24 MW/cm2-stras。为了验证模块的实际操作的可行性，分析了光纤端面法线与入射光束之间的夹角对耦合效率的影响，结果显示该夹角对模块的耦合效率影响较小。同时，应用ANSYS软件对模块散热情况的分析结果可知，模块散热性能良好。故该模块各项性能良好，可靠性较高，实现了高功率、高亮度、多波长的多单管半导体激光器光纤耦合模块的设计目的。

In order to develop a wavelengths ultiplexing fiber-coupled module of high output power and high power denisty on the basis of single emitter semiconductor laser diode, and design a kind of new pump laser for fiber laser, a new-type fiber-coupled module composed of 30 LDs was designed based on ZEMAX optical design software, which can output three kinds of wavelengths. After collimation by micro lens, including FACs and SACs, spatial multiplexing, wavelength multiplexing, diversion by special mirrors, focusing by focus lens and coupling to a fiber, the module can produce above 357.91 W output power from a standard fiber with core diameter of 105 μm and numerical aperture (NA) of0.22. The total fiber coupling efficiency is about 99.42%, and the power density is 27.24 MW/cm2. To test the practical feasibility of the module, analyzed the influence from the angle between the incident beam and the normals of optical fiber end face on the coupling efficiency, the results showed the effects from the angle is so tiny that can be neglected. At the same time, the application of ANSYS software for the thermal analysis of this module shows that the cooling performance of the module is pretty good. Therefore this modules performance is positive and of high reliability, which can meet the demand of single emitter semiconductor laser fiber-coupled module which is of high power, high brightness and multiple wavelengths. Additionally, this design is of great guiding significance for practical production.