激光与光电子学进展, 2019, 56 (9): 091401, 网络出版: 2019-07-05   

单道次激光熔覆304不锈钢数值模拟与实验研究 下载: 1181次

Numerical Simulation and Experimental Study of Single-Track Laser Cladding of 304 Stainless Steels
作者单位
西安科技大学机械工程学院, 陕西 西安 710054
摘要
利用ANSYS有限元分析软件数值模拟激光熔覆过程,得到了不同工艺参数下的温度场。在与数值模拟相同条件下,在27SiMn钢表面进行激光熔覆304不锈钢实验,利用光学显微镜观察熔覆层的显微组织。结果表明,熔池内峰值温度随着激光功率的增大而增大,随着激光扫描速度的增大而减小;数值模拟与实验所得到的熔池几何尺寸基本一致;当激光功率为2500 W,扫描速度为13 mm/s时,熔覆层的晶粒细小,组织致密,熔覆层成形性最佳。
Abstract
The ANSYS software was used to perform the numerical simulation of laser cladding. The temperature field was determined under different technological parameters. An experiment involving laser cladding of 304 stainless steel on 27SiMn steel surface was conducted under the same conditions as those in the numerical simulation. The microstructure of the cladding layer was observed using an optical microscope. The results show that the peak temperature in the molten pool increases as the laser power increases, and decreases as the scanning speed increases. The geometrical dimension of the molten pool obtained via numerical simulation is consistent with that obtained in the experiment under the same conditions. Under the laser power of 2500 W and scanning speed of 13 mm/s, the cladding layer has relatively small grains and compact structure, and shows optimal formability.

郭卫, 张亚普, 柴蓉霞. 单道次激光熔覆304不锈钢数值模拟与实验研究[J]. 激光与光电子学进展, 2019, 56(9): 091401. Wei Guo, Yapu Zhang, Rongxia Chai. Numerical Simulation and Experimental Study of Single-Track Laser Cladding of 304 Stainless Steels[J]. Laser & Optoelectronics Progress, 2019, 56(9): 091401.

本文已被 11 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!