中国激光, 2020, 47 (4): 0401005, 网络出版: 2020-04-08   

用于垂直腔面发射激光器的GaAs/AlGaAs的ICP刻蚀工艺研究 下载: 1386次

ICP Etching Process of GaAs/AlGaAs for Vertical-Cavity Surface-Emitting Lasers
作者单位
1 长春大学理学院, 吉林 长春 130022
2 爱发科(苏州)技术研究开发有限公司, 江苏 苏州 215026
摘要
采用电感耦合等离子体(ICP)刻蚀设备对应用于垂直腔面发射激光器的GaAs/AlGaAs材料进行刻蚀工艺研究。该刻蚀实验采用光刻胶作为刻蚀掩模,Cl2/BCl3作为刻蚀工艺气体,通过实验分析总结了ICP源功率、射频偏压功率和腔体压强对GaAs/AlGaAs材料和掩模刻蚀速率的影响。利用扫描电子显微镜观察不同参数条件对样品侧壁垂直度和底部平坦度的影响。最终在保证高刻蚀速率的前提下,通过调整优化各工艺参数,得到了侧壁光滑、底部平坦的圆台结构。
Abstract
We use inductively coupled plasma (ICP) etching equipment to study the etching process for GaAs/AlGaAs materials used in vertical-cavity surface-emitting lasers. During the ICP etching process, photoresist is used as the etching mask, whereas Cl2/BCl3 is used as the etching gas. The ICP antenna power, radio frequency bias power, and cavity pressure in case of the GaAs/AlGaAs materials and masks are analyzed and summarized through experiments. Further, scanning electron microscopy is used to investigate the effects of different parameter conditions on the verticality and bottom flatness of the pattern sidewalls. Finally, a round-table structure with smooth sidewalls and flat bottom is obtained by adjusting and optimizing the parameters during each process to ensure a high etching rate.

王宇, 周燕萍, 李茂林, 左超, 杨秉君. 用于垂直腔面发射激光器的GaAs/AlGaAs的ICP刻蚀工艺研究[J]. 中国激光, 2020, 47(4): 0401005. Wang Yu, Zhou Yanping, Li Maolin, Zuo Chao, Yang Bingjun. ICP Etching Process of GaAs/AlGaAs for Vertical-Cavity Surface-Emitting Lasers[J]. Chinese Journal of Lasers, 2020, 47(4): 0401005.

本文已被 2 篇论文引用
被引统计数据来源于中国光学期刊网
引用该论文: TXT   |   EndNote

相关论文

加载中...

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!