雷达仿真实验用卧式三轴飞行仿真转台的三轴交汇中心与射频阵列仿真系统球面的球心同心, 转台的初始姿态满足一定要求, 以减小雷达仿真时的误差。为了三轴转台位姿的精确对准, 提出了一种能补偿经纬仪竖直轴线铅垂度误差和俯仰轴零位误差的对准方案, 首先根据精确的已知基点的坐标, 通过经纬仪对各基点的观测结果采用最小二乘迭代处理方法, 确定了经纬仪的三轴交汇中心的位置, 再通过经纬仪对转台的内、中环轴轴端安装的靶标进行观测, 确定了三轴转台的位置与初始姿态。通过实际测试与调整, 解算出了三轴转台的三轴交汇中的坐标为-0.485, 0.203和-0.475 mm, 外环轴指向误差为-59″。该测试结果在位置误差1 mm, 姿态误差2′的要求范围之内, 实现了三轴转台的位姿对准任务。

Three-axis intersecting point of horizontal three-axis flight simulator used for radar simulation experiment shall be homocentric with spherical center of the RF array simulation system, and initial attitude of the simulator shall meet the requirements to reduce the radar simulation error. To achieve accurate position and attitude alignment of the simulator, an alignment method which can compensate for plumb error in vertical axis of the theodolite and the initial angular error in the pitch axis was put forward. Method: first, identified the position where three-axis intersecting point of the theodolite was located by adopting the Iterative Least Square Method based on accurate coordinates of the known base points and observation results of these base points; then determined the position and initial attitude of the three-axis simulator through observation in the targets installed at inner axis and middle axis end of the simulator by theodolite. Through actual test and adjustment, coordinate values in three-axis intersection of the simulator were calculated to be -0.485 mm, 0.203 mm and -0.475 mm, with an outer ring direction error of -59″. The test results, within the position error range of 1 mm and attitude error range of 2′, help achieve position and attitude alignment of the three-axis simulator.