Matter and Radiation at Extremes, 2018, 3 (4): 145, Published Online: Oct. 2, 2018  

Influence of structural factors on the strength properties of aluminum alloys under shock wave loading

Author Affiliations
1 Institute of Problems of Chemical Physics RAS, Chernogolovka, Russia
2 National Research Tomsk State University, Tomsk, Russia
Abstract
The results of measurements of the strength characteristics - Hugoniot elastic limit and spall strength of aluminum and aluminum alloys in different structural states under shock wave loading are presented. Single-crystals and polycrystalline technical grade aluminum А1013 and aluminum alloys А2024, АА6063Т6, А1421, A7, А7075, А3003, A5083, АА1070 in the initial coarse-grained state and ultrafine-grained or nanocrystalline structural state were investigated. The refinement of the grain structure was carried out by different methods of severe plastic deformation such as Equal Chanel Angular Pressing, Dynamic Channel Angular Pressing, High-Pressure Torsion and Accumulative Roll- Bonding. The strength characteristics of shock-loaded samples in different structural states were obtained from the analysis of the evolution of the free surface velocity histories recorded by means of laser Doppler velocimeter VISAR. The strain rates before spall fracture of the samples were in the range of 104-105 s-1, the maximum pressure of shock compression did not exceed 7 GPa. The results of these studies clearly demonstrate the influence of structural factors on the resistance to high-rate deformation and dynamic fracture, and it is much less than under the static and quasi-static loading.

S.V. Razorenov. Influence of structural factors on the strength properties of aluminum alloys under shock wave loading[J]. Matter and Radiation at Extremes, 2018, 3(4): 145.

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!