预张拉光纤布拉格光栅应变传递规律实验研究

利用裸光纤布拉格光栅测量结构物表面应变，基于光纤层-胶结层-基体层的应变传递模型，从理论上分析了预张拉对应变传递率的影响,并通过实验进行了验证。利用预张拉光栅与未预张拉光栅同时测量了等强度梁正反两面的应变。实验中为排除黏贴长度及厚度的影响，采用LOCTITE点胶机控制滴胶量，得到应变随荷载变化的曲线，并与等强度梁理论应变值进行对比，得到应变传递率与荷载的关系曲线。结果表明，在测拉应变时，预张拉光栅的应变传递率高于未预张拉光栅的应变传递率，且两者都在96%以上；在测压应变时，预张拉光栅的应变传递率低于未预张拉光栅的应变传递率，且两者均在95%以上，与理论分析相符。这说明对测拉应变的实验，预张拉能提高应变传递率；而对测压应变的实验，预张拉会降低应变传递率。

Abstract

In view of measuring strain on the structure surface by the bare fiber Bragg grating（FBG）, and based on the strain transfer model of fiber layer-cement layer-matrix layer, the prestressing effect on the strain transfer rate is studied theoretically and experimentally. The strain on both positive and negative sides of the equal strength beam is measured by means of the prestressing FBG as well as the normal FBG. In order to eliminate the effect of the length and thickness of the cement, the LOCTITE dispenser is used to control the amount of cement. The curve of strain changing with load is obtained. And through comparing with the theoretical strain value of equal strength beam, the curve of strain transfer rate changing with load is received. The results show that the rate of the prestressing FBG is higher than that of the normal FBG for tensile strain mearsuremnet, both of which are above 96%, while the rate of the prestressing FBG is lower than that of the normal FBG for compressive strain mearsuremnet, both of which are above 95%. It corresponds with the theoretical analysis. It proves that the strain transfer rate is improved thanks to the prestressing in the experiment of tensile strain. On the contrary, the rate is reduced because of the prestressing in the experiment of compressive strain.

参考文献

[1] Meltz G, Morey W W, Glenn W H. Formation of Bragg gratings in optical fibers by a transverse holographic method［J］. Optics Letters, 2089, 14(15): 823-825.

[2] 孙圣和. 现代传感器发展方向［J］. 电子测量与仪器学报, 2009, 23(1): 1-10.

Sun Shenghe. Development trend of modern sensor［J］. Journal of Electronic Measurement and Instrument, 2009, 23(1): 1-10.

[3] Leung C K Y, Wan K T, Inaudi D, et al. Review: optical fiber sensors for civil engineering applications［J］. Materials and Structures, 2013, 48(4): 871-906.

[4] López-Higuera J M, Cobo L R, Incera A Q, et al. Fiber optic sensors in structural health monitoring［J］. Journal of Lightwave Technology, 2011, 29(4): 587-608.

[5] 熊稚莉, 梁大开, 李彤韡, 等. 基于关联维数的冲击载荷光纤布拉格光栅定位［J］. 中国激光, 2016, 43(8): 0804001.

Xiong Zhili, Liang Dakai, Li Tongwei, et al. Impact localization by using optical fiber Bragg grating sensors based on correlation dimension［J］. Chinese J Lasers, 2016, 43(8): 0804001.

[6] 赵洪霞, 鲍吉龙, 陈莹. 利用剪滞法对包覆光纤布拉格光栅应力传递规律的研究［J］. 中国激光, 2006, 33(5): 636-640.

Zhao Hongxia, Bao Jilong, Chen Ying. Research on stress transferring rules for cladded fiber Bragg grating by using shear lag theory［J］. Chinese J Lasers, 2006, 33(5): 636-640.

[7] Ansari F, Yuan L B. Mechanics of bond and interface shear transfer in optical fiber sensors［J］. Journal of Engineering Mechanics, 2098, 124(4): 385-394.

[8] Li D S, Li H N, Ren L, et al. Strain transferring analysis of fiber Bragg grating sensors［J］. Optical Engineering, 2006, 45(2): 402-409.

[9] 田石柱, 张国庆, 王大鹏. 表面式光纤布拉格光栅传感器应变传递机理的研究［J］. 中国激光, 2014, 41(8): 0805005.

Tian Shizhu, Zhang Guoqing, Wang Dapeng. Study on strain transfer mechanism of surface fiber Bragg grating sensor［J］. Chinese J Lasers, 2014, 41(8): 0805005.

[10] 吴永红, 邵长江, 屈文俊, 等. 光纤光栅应变传感器光-力转换的非线性方程［J］. 仪器仪表学报, 2010, 31(9): 2046-2051.

Wu Yonghong, Shao Changjiang, Qu Wenjun, et al. Nonlinear opto-mechanical transformation equation for FBG strain sensors［J］. Chinese Journal of Scientific Instrument, 2010, 31(9): 2046-2051.

[11] 张桂花, 柴敬, 李旭娟, 等. 基片式光纤光栅应变传感器的应变传递研究［J］. 激光与光电子学进展, 2014, 51(1): 010601.

Zhang Guihua, Chai Jing, Li Xujuan, et al. Research on strain transfer of surface fiber grating sensor［J］. Laser & Optoelectronics Progress, 2014, 51(1): 010601.

[12] 李红, 祝连庆, 刘锋, 等. 裸光纤光栅表贴结构应变传递分析与实验研究［J］. 仪器仪表学报, 2014, 35(8): 2044-2050.

Li Hong, Zhu Lianqing, Liu Feng, et al. Strain transfer analysis and experimental research of surface-bonded bare FBG［J］. Chinese Journal of Scientific Instrument, 2014, 35(8): 2044-2050.

[13] 吴俊, 陈伟民, 章鹏, 等. 金属直接连接的布拉格光纤光栅应变测量方法［J］. 仪器仪表学报, 2012, 33(12): 2709-2713.

Wu Jun, Chen Weimin, Zhang Peng, et al. Strain sensing method based on directly metallized bonding FBG to substrate［J］. Chinese Journal of Scientific Instrument, 2012, 33(12): 2709-2713.

[14] 赵雪峰, 宋钢兵, Michael Fernandez, 等. 一种预张拉大标距光纤光栅应变传感器的研究［J］. 光电子·激光, 2009, 20(5): 576-579.

Zhao Xuefeng, Song Gangbing, Michael Fernandez, et al. Research on one kind of long sensing gauge fiber Bragg grating sensor with pretension［J］. Journal of Optoelectronics·Laser, 2009, 20(5): 576-579.

[15] 孙阳阳, 王源, 章征林, 等. 表面粘贴式光纤布拉格光栅应变传递规律分析与实验研究［J］. 功能材料, 2016, 47(7): 07046-07055.

Sun Yangyang, Wang Yuan, Zhang Zhenglin, et al. Analysis and experimental research on the principle of surface bonded FBG strain transfer［J］. Functional Materials, 2016, 47(7): 07046-07055.

[16] 张文晓, 何秀凤. 粘贴式光纤光栅传感器应变传递影响因素分析［J］. 工程勘察, 2013(6): 82-86.

Zhang Wenxiao, He Xiufeng. Analysis of strain transfer factors of pasted optical fiber Bragg grating sensor［J］. Geotechnical Investigation ＆ Surveying, 2013(6): 82-86.

由泽伟, 王源, 孙阳阳, 黄肖迪, 章征林. 预张拉光纤布拉格光栅应变传递规律实验研究[J]. 激光与光电子学进展, 2016, 53(11): 110501. You Zewei, Wang Yuan, Sun Yangyang, Huang Xiaodi, Zhang Zhenglin. Experimental Research on Strain Transfer Rules of Prestressing Fiber Bragg Grating[J]. Laser & Optoelectronics Progress, 2016, 53(11): 110501.

预张拉光纤布拉格光栅应变传递规律实验研究

关于本站 Cookie 的使用提示

全站搜索

预张拉光纤布拉格光栅应变传递规律实验研究

相关论文

相关资讯

关于本站 Cookie 的使用提示

全站搜索