溶胶-凝胶法制备Li1.0Nb0.6Ti0.5O3∶Eu3+红色荧光粉

采用溶胶-凝胶法制备Li1.0Nb0.6Ti0.5O3∶Eu3+红色荧光粉, 讨论了煅烧温度、煅烧时间以及Eu3+掺杂浓度对样品发光性能的影响。通过XRD、荧光光谱分别对样品的性能进行表征, 结果表明: 样品的晶相结构为“M-相(M-phase)”。在466 nm蓝光激发下, 合成的荧光粉具有橙光(593 nm)和红光(612 nm)发射。发光强度随着煅烧温度的升高先增大后减小, 最佳的煅烧温度为850 ℃。同时, 随着煅烧时间的增加, 发光强度先增大后减小, 最佳煅烧时间为6 h。当Eu2O3掺入质量分数为2.5%时, 样品的发光强度达到最大。Li1.0Nb0.6-Ti0.5O3∶Eu3+红色荧光粉在白光LED的应用中具有潜力。

Abstract

Li1.0Nb0.6Ti0.5O3∶Eu3+ red phosphor was synthesized by sol-gel method. The influences of the sintering temperature, the sintering time and the Eu3+ doping concentration on the luminous properties of the samples were discussed. The properties of the samples were characterized by X-ray diffraction(XRD) and photoluminescence spectroscopy, respectively. The results show that the samples are consist of “M- phase”. Under the excitation of 466 nm, the orange emission at 593 nm and the red emission at 612 nm can be observed. The emission intensity increases with the increasing of the sintering temperature firstly and then decreases. The optimum sintering temperature is about 850 ℃. Moreover, the emission intensity increases with the increasing of the sintering time firstly and then decreases. The relatively high emission intensity of the sample can be obtained when the sintering time is 6 h. In addition, the optimal doping mass fraction of Eu2O3 is about 2.5%. Therefore, the red phosphor has potential application in the white-LED field.

参考文献

[1] 雷玉堂, 黎慧. 未来的照明光源——白光LED技术及其发展［J］. 光学与光电技术, 2003, 1(5):33.

LEI Y T, LI H. Lighting source in the future—white-light LED ［J］. Opt. Optoelectron. Technol., 2003, 1(5):33.(in Chinese)

[2] 刘行仁. 白光LED固态照明光转换荧光体［J］. 发光学报, 2007, 28(3):291-301.

LIU X R. Phosphors for white LED solid state lighting ［J］. Chin. J. Lumin., 2007, 28(3):291-301. (in Chinese)

[3] 胡运生, 庄卫东, 叶信宇, 等. 半导体照明用荧光粉的研究进展［J］. 新材料产业, 2008(5):50-54.

HU Y S, ZHUANG W D, YE X Y, et al.. Research progress of phosphors for semiconductor lighting ［J］. Adv. Mater. Ind., 2008(5):50-54. (in Chinese)

[4] 曾琦华, 张信果, 梁宏斌, 等. 白光LED用荧光粉的研究进展［J］. 中国稀土学报, 2011, 29(1):8-17.

ZENG Q H, ZHANG X G, LIANG H B, et al.. Progress of research on phosphor for white-light emitting diodes ［J］. J. Chin. Rare. Earth. Soc., 2011, 29(1):8-17. (in Chinese)

[5] 游维雄, 孙坤磊, 肖宗梁, 等. Y2Ti2O7∶Tm3+的制备及其发光性能研究［J］. 发光学报, 2015, 36(3):267-271.

YOU W X, SUN K L, XIAO Z L, et al.. Synthesis and luminescence properties of Y2Ti2O7∶Tm3+ phosphor ［J］. Chin. J. Lumin., 2015, 36(3):267-271. (in Chinese)

[6] LI X Y, ZHOU J. Characterization of luminescent LTCC composite materials for white LED package ［J］. Adv. Mater. Res., 2014, 873:761-769.

[7] YAN C, SUN L, LIAO C, et al.. Eu3+ ion as fluorescent probe for detecting the surface effect in nanocrystals ［J］. Appl. Phy. Lett., 2003, 82(20):3511-3514.

[8] BAE J S, JEONG J H. Improved photoluminescence of pulsed-laser-ablated Y2O3∶Eu3+ thin-film phosphors by Gd substitution ［J］. Appl. Phy. Lett., 2003, 82(21):3629-3631.

[9] BORISEVICH A, DAMES P K. Microwave dielectric properties of Li1+x-yNb1-x-3yTix+4yO3(M=Nb5+,Ta5+) solid solutions ［J］. J. Eur. Ceram. Soc., 2001, 21(10-11):719-1722.

[10] ZENG Q, LI W, SHI J L, et al.. A new microwave dielectric ceramic for LTCC applications ［J］. J. Am. Ceram. Soc., 2006, 89(5):1733-1735.

[11] ZENG Q, LI W, SHI J L, et al.. Effect of B2O3 on the sintering and microwave dielectric properties of M-phase LiNb0.6-Ti0.5O3 ceramics ［J］. J. Eur. Ceram. Soc., 2007, 27(1):261-265.

[12] KANG D H, NAM K C, CHA H J. Effect of Li2O-V2O5 on the low temperature sintering and microwave dielectric properties of Li1.0Nb0.6Ti0.5O3 ceramics ［J］. J. Eur. Ceram. Soc., 2006, 26(10-11):2117-2121.

[13] HAYASHI H, NAKANO H, JONES M I. Microstructure and luminescence of Eu-doped Li1+x-yNb1-x-3y -Tix+4yO3 solid solutions with superstructure ［J］. J. Ceram. Soc. Jpn., 2010, 118(1375):226-230.

[14] HAYASHI H, NAKANO H, JONES M I. Microstructure and luminescence of rare earth doped Li(Nb,Ti)O3 solid solutions ［J］. J. Mater. Sci. Eng., 2011, 18(8):082018-1-4.

[15] 王飞, 周志勇, 曾群, 等. Eu3+掺5Li2O-1Nb2O5-5TiO2发光陶瓷的制备及性能研究［J］. 发光学报, 2017, 38(3): 269-273.

WANG F, ZHOU Z Y, ZENG Q, et al.. Preparation and properties of Eu-doped 5Li2O-1Nb2O5-5TiO2 ceramics ［J］. Chin. J. Lumin., 2017, 38(3):269-273. (in Chinese)

[16] 何晓林, 杨定明, 廖其龙, 等. 溶胶-凝胶法制备Li2ZnSiO4∶Sm3+红色荧光粉［J］. 人工晶体学报, 2014, 43(3):532-536.

HE X L, YANG D M, LIAO Q L, et al.. Preparation of red phosphor Li2ZnSiO4∶Sm3+ by sol-gel method ［J］. J. Synth. Cryst., 2014, 43(3):532-536. (in Chinese)

[17] 曹文强, 李峻峰, 何苗苗, 等. AlPO4∶xEu3+红色荧光粉的制备及发光性研究［J］. 电子元件与材料, 2015, 34(12):44-47.

CAO W Q, LI J F, HE M M, et al.. Preparation and luminescent properties of AlPO4∶xEu3+ red-emitting phosphor ［J］. Electron. Compon. Mater., 2015, 34(12):44-47. (in Chinese)

[18] 董其铮, 何玲, 孙卫民. 溶胶凝胶法制备(Y,Gd)(V,P)O4∶Eu3+纳米红色荧光粉［J］. 兰州理工大学学报, 2016, 42(1):31-34.

DONG Q Z, HE L, SUN W M. Preparation of red nano-phosphor (Y,Gd)(V,P)O4∶Eu3+ by using sol-gel method ［J］. J. Lanzhou. Univ. Technol., 2016, 42(1):31-34. (in Chinese)

[19] NAKANO H, FURUYA S, FUKUDA K, et al.. Synthesis and luminesc;ence enhancement of Eu3+, Sm3+, co-doped Li1.11Ta0.89Ti0.11O3 phosphor ［J］. Mater. Res. Bull., 2014, 60:766-770.

[20] KANG M, LIU J, YIN G F, et al.. Preparation and characterization of Eu3+-doped CaCO3 phosphor by microwave synthesis ［J］. Rare Met., 2009, 28(5):439-444.

[21] SUN L D, QIAN C, LIAO C S, et al.. Luminescence phosphors of Li+ doped nanosized Y2O3∶Eu3+ ［J］. Solid State Commun., 2001, 119(6):393-396.

[22] SETLUR A A, COMANZO H A, SRIVASTAVA A M, et al.. Spectroscopic evaluation of a white light phosphor for UV-LEDs-Ca2NaMg2V3O12∶Eu3+ ［J］. J. Electrochem. Soc., 2005, 152(12):205-208.

周鹤, 周志勇, 曾群, 姚春凤, 刘磊. 溶胶-凝胶法制备Li_1.0Nb_0.6Ti_0.5O₃∶Eu³⁺红色荧光粉[J]. 发光学报, 2018, 39(7): 909. ZHOU He, ZHOU Zhi-yong, ZENG Qun, YAO Chun-feng, LIU Lei. Preparation of Eu³⁺ Doping Li_1.0Nb_0.6Ti_0.5O₃ Red Phosphor by Sol-gel Method[J]. Chinese Journal of Luminescence, 2018, 39(7): 909.

溶胶-凝胶法制备Li_1.0Nb_0.6Ti_0.5O₃∶Eu³⁺红色荧光粉

关于本站 Cookie 的使用提示

全站搜索